The install is pretty straight forward. The steps are as follows:
|
Acquire a 2.2k-Ohm Resistors with a 1/2 watt 5% tolerance
|
|
Locate the intake air temperature sensor
|
|
Remove the wire cover and there should be 2 wires, a red/yellow and a black wire
|
|
The red/yellow is the wire that you want to sauder the resistor in series
|
|
A resistor is non-directional and can be installed in whatever direction
|
|
Electrical tape should be used to cover the resistor and the wires
|
|
Voila, instant cold air intake
|
A picture of the sensor located near the maf since I have a filter charger.
